Kapitel-Icon

Parameters of the cooling curve for vacuum conditioning

  1. active
  2. active

In most vacuum conditioning installations, a cooling curve can be created by entering pairs of values for time and pressure. This results in the cooling time and the final pressure of the curve. The following figure shows an example of a cooling curve in which the pressure is reduced every 8 seconds until a final pressure of 200 mbar is reached. The curve is set in such a way that gentle and even cooling is achieved. The cooling curve is then shown on the installation display as a function of time and pressure. (The curve shown is an installation in which a maximum of 20 pairs of values can be set).

The main setting parameters for vacuum conditioning are the cooling time, the final pressure and the holding time.

The cooling time describes the time from the start of the cooling process in the chamber until the final pressure is reached.

Comparison of cooling times

The final pressure is the lowest pressure in the chamber at the end of the cooling time. The final pressure determines the boiling temperature of the water in the baked goods and therefore also the core temperature of the baked goods in the cooling process. During the cooling process, water is evaporated from the baked goods until its temperature reaches the boiling temperature corresponding to the pressure.

The holding time is a stabilisation phase after the final pressure has been reached. In this phase, the final pressure is maintained for a defined time, depending on the type of baked goods. Pre-baked goods without significant crust colour benefit from a longer holding time to prevent creases.